Hunt CCTV HTP-T32G28D, User Manual

Page: 26 / 35

HTP-T32G28D User Manual
-25-
The HTP-T32G28D has one sensor port and one alarm port. When a decoder system instead of a PC client is
connected to a HTP-T32G28D, one system becomes a Local system and the other a Remote system (Generally
a system which is being used by the user is called as Local system). Then, actions for events can be configured
for events from the remote system as well as for local system. For example, it is possible to turn on an alarm
device in local (center) decoder system when a sensor device in remote (site) IP camera is triggered.
Local
section configures the actions for events from local (self) system, and configuration activates local devices and
Remote
sections configure the actions for events from remote (peer) system.
. The following table lists the possible actions for events.
Action Description
Sensor In
One sensor in port
Alarm out Triggers alarm (relay) port.
E-mail
Sends E-mail to the specified address. AVI file can be
attached
FTP Upload AVI file to a specified FTP server
„ Sensor
Configure the actions when the sensor is activated. Multiple actions can be set for a single event.
„ On Video Loss
Configure the actions when video input signal is lost. Multiple actions can be set for a single event.
„ On Motion
Configure the actions when motion is detected. Multiple actions can be set for a single event.
„ On Disconnect
Configure the actions when the link (connection) with peer system is disconnected. Multiple actions can
be set for a single event.
„ Alarm activation duration
Set the duration of alarm activation in case of an event. If it is set to continuous, it will be in active state
until an operator reset it manually.
„ E-mail Notification
Specify the information to send E-mail as the action of an event. The address of mail (SMTP) server