3
Caution
Important
●
The base must be fastened to the ground using concrete around the pegs.
●
The greenhouse must be securely fastened to the base.
●
The base must be 100% level and square. The easiest way to ensure that the base is square is
to measure across the diagonals. The diagonals should measure the same.
●
We recommend greasing self tapping screws for easier assembly.
●
Glazing should only be carried out in fairly calm weather.
●
Make sure that the greenhouse is square before starting to glaze.
●
We recommend using gloves while glazing.
●
An assistant will make the job much easier.
Tools
The greenhouse is assembled by means of the following tools:
●
Spirit level
●
Spanner/socket spanner 8 and 10 mm
●
Screw driver (a battery drill with a clutch is very handy for quicker assembly)
●
Caulking gun
Peel back approximately 2 inches (50mm) of film from
both sides before installing. Remove all film immediately
after the construction is completed.
Mark the sheets with a
permanent felt tip pen to indicate the correct side to the
sun.
The UV
-
protected side of the sheet has printing on the film
and must face towards the sun.
The side with the clear
film goes to the inside. Remove all film.
Please put on gloves to avoid cutting your hands.
Treat the polycarbonate carefully so it is not bent or
damaged.
Keep the polycarbonate away from material that could
scratch it. Don’t put the edges on the ground.
