If you are using the 105SX in Simulator when no transducer is connected,
any selected options are lost when the unit is powered off. The 105SX
will return to Factory Settings, or options selected when last used with a
transducer, if no transducer is connected.
IMPORTANT: A transducer must be connected to the 105SX in
order to retain user settings selected when in simulator mode. If
no transducer is detected, the unit defaults to pre-selected options
when powered off.
What You See On-Screen
Your 105SX uses a 128 x 64 matrix
FSTN LCD display. This display provides
outstanding viewability in all light
conditions over a wide range of
temperatures.
At initial power-up, the 105SX uses
settings that were set at the factory.
After initial use, the 105SX will
remember the settings you enter.
There are several elements on-screen
that are common to all modes of
operation.
Speed/Temperature.
The initial screen layout takes one of two basic forms
depending on presence of accessories such as Temperature or
Speed/Temperature sensors. Figure A shows the default view when the
Speed/Temp or Temperature accessory is installed. Figure B shows the default
view when no accessory is installed.
Depth.
The digital depth number shows the water depth directly beneath
the transducer location.
Depth Range.
The depth range is shown to the right of the screen. The
upper number is 0 indicating the surface of the water. The lower number
is one of the nine depth ranges available that best match the depth of
the water. As the depth of the water changes, the range changes as
necessary in order to retain a bottom representation on-screen.
8
USING THE 105SX
WHAT YOU SEE ON-SCREEN
Figure A
Summary of Contents for Single Beam 105SX
Page 1: ... Operations Manual ...