Route the Cables
In this procedure, you will route the power and transducer jumper cables on
the underside of the base, and attach the tie-down straps that will be used to
secure the battery to the base in a later procedure.
1.
Turn the base upside down,
then thread the two included
hook and loop battery tie-
down straps from the bottom
of the base up through each
side of the battery well, using
the strap holes (see the
illustration
Attaching
the
Battery Tie-Down Straps
).
2.
Route the power cable from
the mount DOWN through the
center hole of the base. Route
the transducer jump cable UP
through the base and mount.
Figure 36
Attaching the Battery Tie-Down Straps
battery tie-down straps
Pulling the Cables Through the Base
Figure 37
27
y.
ntrol
ace,
the
PiranhaMAX Portable Case Assembly
PiranhaMAX_Manual_532273-1EN_A.qxp:Layout 1 4/18/14 11:34 AM Page 27