23
Setup Guide
General Settings
|
Select Time and Date Format, and Units of Measurement
Select Units of Measurement
1. Select
Units
and open the submenu.
2. Select a menu option and open the submenu.
3. Select a setting and press the CHECK key
to confirm the
selection.
4. Tap the back arrow on-screen or press the EXIT key
to return
to the submenu.
5. Repeat steps 2 through 4 to change another setting.
6. Tap the back arrow on-screen or press the EXIT key
to return
to the main menu.
7. Select additional settings as needed. Tap the right arrow on-screen
or press the RIGHT ARROW key
on the keypad to proceed to the
next menu dialog box.
Sonar
|
Confirm Transducer Setup and Set the Depth Offset
The control head will default to the transducer that was included with your unit and automatically select sonar settings based on the
transducer’s capabilities. If your control head is compatible with an accessory transducer, and it is connected to the control head, use
Transducer Setup to select the accessory transducer. Use the following instructions to confirm transducer setup and set the depth offset.
Confirm Transducer Setup
1. Select
Transducer Setup
and open the submenu.
2. Review the current menu settings.
To make changes:
Select a setting and press the CHECK key
to
confirm the selection. If your transducer supports multiple sonar
beams (Side Imaging, Down Imaging, and 2D Sonar), select each
one you plan to use.
3. Tap the back arrow on-screen or press the EXIT key
to return
to the main menu.
Set the Depth Offset
1. Select
Depth Offset
and open the submenu.
2. Drag the slider, or use the Rotary Dial, to adjust the setting.
3. Tap the back arrow on-screen or press the EXIT key
to return
to the main menu.
4. Select additional settings as needed. Tap the right arrow on-screen
or press the RIGHT ARROW key
on the keypad to proceed to the
next menu dialog box.
menu options
current menu option setting
back
submenu
current menu option setting submenu
current menu option setting
Summary of Contents for ONIX10
Page 4: ......
