Sensitivity
Sensitivity
controls how much detail is shown on
the display and will adjust the sensitivity of all sonar frequencies. Increasing the
sensitivity shows more sonar returns from small baitfish and suspended debris in
the water; however, the display may become too cluttered. When operating in very
clear water or greater depths, increased sensitivity shows weaker returns that may
be of interest. Decreasing the sensitivity eliminates the clutter from the display that
is sometimes present in murky or muddy water. If Sensitivity is adjusted too low, the
display may not show many sonar returns that could be fish.
NOTE:
The Sensitivity setting is a global setting and will adjust the sensitivity of all sonar
frequencies, as compared to specific sensitivity adjustments (such as 83 kHz Sensitivity,
455 kHz Balance or Wideside Sensitivity) which allow you to adjust the level of sensitivity
for one specific beam at a time.
To adjust the Sensitivity:
1. Highlight Sensitivity on the Sonar X-Press
TM
Menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to increase or decrease the
Sensitivity setting. (Low = 1, High = 20, Default = 10)
Sensitivity at Low
Sensitivity at Medium
Sensitivity at High
27
Side
(WideSide® transducer: WideSide® view only)
Side
sets which transducer beam from the WideSide® Transducer is shown in the
WideSide® View. A WideSide® transducer must be connected to the 700 Series™
Fishing System. The Side menu choice is available when Transducer Select is set to
WideSide® (see
Sonar Menu Tab: Transducer Select
) and can only be accessed from
the Sonar X-Press
TM
menu when you are in WideSide® view.
NOTE:
Side requires the purchase of the WideSide® transducer. You can visit our website
at
www.humminbird.com
to order this accessory online or contact our Customer
Resource Center at 1-800-633-1468.
To adjust the Side:
1. Make sure you are in WideSide® Transducer Mode and that a WideSide®
transducer is connected, then highlight Side on the Sonar X-Press
TM
menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Side setting.
(L [Left], Both, R [Right], Default = Both)
28
531474-1_A_777c2_English.qxd 11/3/2005 8:01 PM Page 34
