Humidex
5
Before Installing
Technical data
Voltage:
115VAC
Amperage
0.26A
Certification: QPS File# LR1079
Dimensions: 9” x 7” x 3”
Capacity:
Up to 750 sq. ft.
Recommended tools required for installation
-
1/4’’ pilot drill bit of 12 inches or more
-
Hole saw with a diameter of 4 ½”, reciprocal saw or, jig saw
-
Measuring tape
-
Hammer
-
Screwdriver
Included parts list
Garage Ventilation System
Manual
4” Exhaust Vent
6x #8x9/16” mod white screws
1Pc. Aluminum Tape
4x #6x2” woodscrew
Control Knob
2x #8x1-1/4” truss screws
Humidity Label
2x #8x1-1/4” yellow anchors
Warranty Card
1pc. 4” vinyl flex
Ideal installation location
When looking for a location to install your new Humidex, make
sure to place it on an outside wall so that the unit can exhaust its air
outside. The unit should be installed near an electrical outlet and, if
possible, in the dampest location. The unit should be installed no
higher than 12 inches off the floor.
Summary of Contents for GVS-H
Page 10: ...Humidex 9 Wiring Diagram ...
