Humidex
7
Installation
Please follow these instructions to install your Humidex properly.
1. From the inside, mark where the center
of the Humidex will be placed and drill
through the wall with a ¼’’x 12’’ pilot bit.
The hole should be approximately
12 inches from the floor. Cut a 4 ½’’ hole
through the wall.
2. From the inside, place the Humidex
against the wall in the mounting position
and mark where the pilot screws will be
placed. Keep in mind that the knob will be
going on the right hand side. Drill
¼’’ holes, and apply anchors with a
hammer.
3. Use tape to fasten the flex pipe over the
exhaust outlet on the back of the Humidex
and fasten 3 screws around the tape into
the outlet collar. Place Humidex into the
predrilled hole and then secure appliance
by fastening to the anchors.
4. From the outside, stretch and cut any
excess flex pipe. Proceed to place vent
collar into the flex and securing in its
correct position by taping and screwing
into the vent collar.
5. Place all 4 #6 x 2’’ screws in a diagonal
pattern to prevent vent twisting, and to
acquire the best fit around your siding.
After placing in the final screw, use
caulking to properly seal around the vent.
*The garage ventilators picture may not be exactly as shown
Summary of Contents for GVS-H
Page 10: ...Humidex 9 Wiring Diagram ...
