www.humancaregroup.com
11
ENGLISH
21. Repeat steps 19‐20 for the other beam’s
extension bracket.
22. Re‐tighten all 8 x bracket bolts and nuts.
Always keep unused brackets! Label (with
model and serial number) and store them
for future use.
23.
Place the extension panel over the beam
extension brackets and using the 4 x
extension panel platform bolts, in the kit,
fit and tighten them all with the 13mm
spanner and 5mm Allen key.
24. Fold the kneebreak panel flat.
25.
Replace the foot end pedestal frame back
on top of the mattress platform.
26. Replace the Pivot Bolts from the outside.
Note 1:
The Nylon Washer sits between the
metal plates (Foot End Pedestal & Foot End
Bracket).
Note 2:
The Metal Washer sits next to the nut.
27. Unfold pedestal to an upright position and
replace the Countersunk Bolts.
28. Re‐tighten (VERY TIGHT) all bolts. Gently
rocking the pedestal end in a completely
vertical position, will aid this.
29. Tighten ALL Nyloc Nuts (Countersunk Bolts
and Pivot Bolts) to prevent these bolts
from coming loose.
30. Reconnect the actuator cable into the mini‐
fit connector, securing retaining clip.
31.
Reconnect the mains power.
32. Re‐check all bed functions with the
handset.
33. The bed may now be put back into service
with a mattress bolster.
Removing the extension kit
To remove an Extension Kit from a bed, follow
the above instructions in reverse.
Human Care strongly recommends against
the use of side rails as they can cause
death and injury.
Do not use forklifts or mechanical
handling equipment to lift this bed unless
it is in its original carton!
Always ensure that:
•
Qualified personnel, only, attend to bed
maintenance. Do Not open or tamper
with any part of the bed, as this may be
dangerous and invalidate the warranty.
•
All locking bolts, pins, screws and circlips
are fully in place, engaged and correctly
tightened before use, and are regularly
checked to be secure, by qualified
maintenance personnel.
•
The battery, is plugged into the control box.
• The bed is not placed against walls that have
power‐outlets, window sills or timber rails.
•
The bed is clear from over‐bed or bedside
tables, or other furniture which could
impede free movement of the bed.
•
The mattress platform is at least 200mm (8“)
