MONTAGEANLEITUNG
TV-Elemente
TYP 4133, 4135, 4138, 4139, 4153, 4155, 4158, 4159,
4143, 4145, 4148, 4149, 4163, 4165, 4168, 4169
TV UNITS
ELEMENTS POUR TV
TV-ELEMENTEN
SEITE 22
MONTAGE · ASSEMBLY ·
MONTAGE · MONTAGE
Attention! Be sure to have the nature of the wall checked by
qualified personnel
before assembly. Assembly should only be carried out by
qualified persons
and the assembly
instructions must be strictly adhered to. The sets of mounting brackets are only suitable if the nature of the wall and the pressure resistance levels meet those stated in the table
below. The unit cannot be mounted on light walls. Please note that a different mounting method must be chosen by
qualified personnel
for other types of wall. hülsta cannot be held
responsible for the correct choice of any other type of mounting. When mounting the unit, please also make sure that there are no electrical installations or other utility lines near the
mounting area. Check this using an appropriate search device. Please note that plastic pipes will not be detected.
The set is only suitable for use in connection with the types of walls stated below.
Please note that the pressure resistance levels must under no circumstances fall below
those stated.
Depth of drilled hole
The hole itself must be deeper than the depth of anchoring.
Depth of drilled hole
Anchoring depth
Mounting set 1 (Mat. no.1410886 /
type 8888
)
for 2 wall connection points
TVM-IGA 6x93
6x
6x
DIN 125 / 6.4
6x
DIN 933 / 6x20
TVM-STV-K 280
1x
6x
TVM-Z-SM
2x
TVM-Z-SH 16x105
TVM-IGA 6x93
9x
9x
DIN 125 / 6.4
9x
DIN 933 / 6x20
TVM-STV-K 280
1x
9x
TVM-Z-SM
4x
TVM-Z-SH 16x105
TVM-STV-K 150
1x
Optional mastic gun (Mat. no.1410888 / type 2222)
1x
The set is only suitable for use in connection with the types of walls stated below.
Please note that the pressure resistance levels must under no circumstances fall below
those stated.
(Vertically) perforated bricks
Pressure resistance
>/= 4 N/mm²
Rotary drilling: With a normal power drill,
without percussion
setting in per-
forated bricks (so that the connecting sections do not break and the hollow
section become too large). Holes must always be thoroughly cleared of any
drilling remains afterwards.
Recommended kind of drilling:
Please also follow the additional enclosed information about
compound mortar from the Tox Company to ensure correct mounting.
Mounting set 2 (Mat. no.1410887 /
type 5555
)
for 3 wall connection points
min. 5 mm
Pressure resistance
>/= 2 N/mm²
Hollow light concrete
blocks
Rotary drilling: With a normal power drill,
without percussion
(so that the
connecting sections do not break and the hollow section become too large).
Holes must always be thoroughly cleared of any drilling remains afterwards.
Recommended kind of drilling:
