HUGONG WAVE 315KD, Operation Manual

Page: 5 / 27

- 4 -
-Consult your doctor before using any electric arc welder or cutting device
-Keep people with pacemakers away from your welding area when welding.
-Do not wrap cable around your body while welding.
-Wrap TIG gun and ground cable together whenever possible.
-Keep TIG gun and ground cables on the same side of your body.
Shielding Gas Cylinders Can Explode
High pressure cylinders can explode if damaged, so treat them carefully.
-Never expose cylinders to high heat, sparks, open flames, mechanical shocks or arcs.
-Do not touch cylinder with TIG gun.
-Do not weld on the cylinder
-Always secure cylinder upright to a cart or stationary object.
-Keep cylinders away from welding or electrical circuits.
-Use the proper regulators, gas hose and fittings for the specific application.
-Do not look into the valve when opening it.
-Use protective cylinder cap whenever possible
1.5 Proper Care, Maintenance and Repair
-Always have power disconnected when working on internal components.
- Do not touch or handle PC board without being properly grounded with a wrist strap. Put PC board in
static proof bag to move or ship.
-Do not put hands or fingers near moving parts such as drive rolls of fan
WAVE 315KD SERIES USE AND CARE

Do not modify the WAVE 315KD SERIES in any way.
Unauthorized modification may impair the
function and/or safety and could affect the life of the equipment. There are specific applications for
which the
WAVE 315KD SERIES
was designed.

Always check of damaged or worn out parts before using the WAVE 315KD SERIES.
Broken
parts will affect the
WAVE 315KD
operation. Replace or repair damaged or worn parts immediately.

Store idle WAVE 315KD.
When
WAVE 315KD SERIES
is not in use, store it in a secure place out of
the reach of children. Inspect it for good working condition prior to storage and before re-use.
Notice
: * If the welder continues to work too long time, the Heat Protection Indicator on the panel
would be on, indicating that the inner temperature rise inside the welder had exceed the
designed permitted temperature. At this time, stop the welding work, wait until the welder cooled inside and
the Heat Protection Indicator turned off, then continue to work again;
* Cut off the power switch and Argon valve, before leaving the welding place temporarily or after the
welding worked finished;
* Welders should wear canvas work clothes and welding face shield to prevent arc light and heat radiation;
* Put light-proof screen around the work area to prevent others influenced by the arc lights.
* Flammable, explosive items could not be put near the welding area;
* Every outlet of the welder should be connected and earthed correctly.