Hughes HN9400, Installation Manual

Page: 102 / 134

Confirming the receive signal
To confirm that the router is properly receiving satellite signals:
1. At the System Control Center, click the
Reception Info
link.
The Reception Information page appears.
2. In the Receive Status field, check the RxCode.
If the RxCode is
Receiver operational (RxCode 5)
the router is receiving signals properly;
proceed to Confirming the transmit signal on page 90.
If any other RxCode appears, the router is not receiving signals properly. Click the RxCode,
and follow the troubleshooting procedure that appears. Click the RxCode for explanation of
the problem and/or troubleshooting information.
Figure 71: Reception Info page
Note: The RxCode shown is an example.
Confirming the transmit signal
To confirm that the router is properly transmitting signals to the satellite:
1. At the System Control Center, click the Transmission Info link.
The Transmission Information page appears.
2.
In the
Transmit Status
field, check the TxCode.
If the TxCode is Transmitter Ready (RxCode 8) the router is transmitting signals properly;
proceed to Confirming that TCP Acceleration is operational on page 91.
If any other TxCode appears, the router is not transmitting signals properly. Click the TxCode
for explanation of the problem and/or troubleshooting information.
Figure 72: Transmission Info page
HN9400 Satellite Router Installation Guide
90
1038554-0001 Revision B
Troubleshooting Chapter 8