Brief Instructions for
Commissioning
USB Stick 8430-1
Item No.: 3200 20 39
VBD 596-10 (11.15)
1. Introduction
These brief instructions describe the commissioning process for the
RADEMACHER USB Stick based on Z-Wave technology.
2. System requirements
You require the following to be able to use the USB Stick 8430-1.
A HomePilot® with software version 4.0.26 * or higher.
3. General safety information
The use of defective equipment can lead to per-
sonal injury and damage to property.
Never use defective or damaged equipment. Please
contact our Customer Service department in this
event .
Only use the USB Stick for configuring and remotely controlling
RADEMACHER equipment based on Z-Wave technology.
Operating conditions
◆
Only use the USB Stick in dry rooms.
◆
The installation and operation of the RADEMACHER radio sys-
tem (and its components) is only permitted for those systems
and devices where a malfunction in the transmitter or receiver
would not cause a danger to personnel or property or where
this risk is already covered by other safety equipment.
NOTE
Radio systems which transmit on the same frequency can cause in-
terference.
4. Proper use
5. Improper use
6. Functional description
The USB Stick serves as a transceiver in combination with the re-
quired HomePilot®.
All registered RADEMACHER devices on the basis of Z-Wave technol-
ogy can be set up and configured using the HomePilot® user interface
on a PC.
Improper use can lead to serious injuries or
property damage.
Never use the existing radio system and its compo-
nents for the remote control of appliances and sys-
tems with increased safety-relevant requirements or
where there is an increased risk of accident. Such situ-
ations require additional safety equipment. Observe
the respective statutory regulations for the installa-
tion of such systems.
Read the HomePilot® operating manual.
You can find a detailed description of the naviga-
tion options and user interface for your HomePilot®
under the following URL:
http://homepilot.local/manual
or in the downloads section of our website:
Enter the respective URL into the address field of
your browser.
*
You can find the current software version for the HomePilot® under:
Configuration / System / Firmware Update / display right.