Hughes HIRD-D2, Owner'S Manual

Page: 16 / 81

SETTING UP THE DIRECTV SYSTEM
P
AGE
2-5
Finding the VCR’s Remote Control Sensor
So that the digital satellite receiver can control your VCR the emitter end of the VCR control cable
must be attached where the VCR’s remote control sensor is located.
On some VCRs this is labeled. You may also find a diagram in your
VCR manual indicating the sensor position. It is commonly
identifiable by a small dark plastic window. For reference, see the
sensor on the digital satellite receiver located in the center.
If the sensor is not labeled or documented, you will need to scan the
front of your VCR with your VCR remote control. Use the following
procedure to accomplish this:
•
Hold the VCR remote control about _-inch from the front left
side of your VCR.
•
Slowly move the remote control to the right repeatedly pressing
the remote control’s power key on and off.
•
Once your VCR responds to your pressing the remote control
power, note the position. This should be the location of your VCR IR
sensor.
Once the sensor position has been determined, temporarily attach the emitter to the area with a piece of
tape until the system can be tested. Refer to the “VCR Setup” section in the chapter “The Digital
Satellite Receiver’s Menu System” to program and test the VCR Control feature.
Upon verifying that the VCR control is functioning properly you can remove the tape and permanently
attach the emitter using the peel-and-stick backing. This attachment should not interfere with normal
VCR operation.
Now You Can Turn It On
Once you have connected everything, you can begin powering up the components. Turn the TV on and
set it to the DIRECTV System channel (3 or 4) or input (video or S-video). Do the same for the VCR,
if applicable. Now turn the digital satellite receiver on. You will see the start-up screen for several
seconds, followed by a black screen with the message at the bottom:
“Searching for satellite signal. To access related utilities, press .”
If so, this is good! If not, try pressing the key while the remote control is in DIRECTV System
mode. If that doesn’t work, check all of the connections.
You’re well on your way to enjoying your DIRECTV System.
Look for indications of the remote control sensor
Scanning for the remote control sensor