Hughes EchoStar Mobile 4500, User Manual, Page: 12 / 41

12
Chapter 1 • Using the Hughes 4500
H62751 Revision C
Chapter 2
Using the Hughes 4500
2.1 Before getting started
Install the USIM into the terminal unit before powering up the unit .
Figure 2: Inserting the USIM card
2.2 Quick start
The Hughes 4500 Terminal must first obtain a GPS fix. In order to do this, the terminal must be
positioned with an open view of the sky. The GPS fix is acquired by the time the terminal is fully booted
up. This time is typically specified at 30 seconds.
2.3 Connecting the terminal to the computer
You can connect your computer to the Hughes 4500 with one or more of the following interfaces:
• Ethernet
•
Micro USB
2.3.1 Connecting by Ethernet
To connect the Hughes 4500 Terminal to a device using Ethernet:
• Connect a standard Ethernet cable to the Ethernet signals of the barrel connector.
2.3.2 Connecting by USB
The common installation access port for installers is the Micro-USB port. To connect the Hughes 4500
Terminal to a device using USB:
•
Connect a standard micro USB cable to the micro USB signals of the barrel connector.
The USB port can be only used for configuration. It cannot be used for
user data connections over the satellite link
.
USB port
LED
USIM port
Factory Defaults
button