BASSBASE 400 - MANUAL
REAR PANEL:
FOOTSWITCH VARIMETRIC: Connect a standard single-channel footswitch to this jack. If you use a
HUGHES & KETTNER FS-1, its LED will illuminate when you activate the VARIMETRIC EQ.
I
TUNER OUT: Output jack for an external tuning device.
FOOTSWITCH
FX LOOP:
Connect a standard single-
channel footswitch to this
jack. If you use a HUGHES
& KETTNER FS-1, its LED
will illuminate when you
activate the FX LOOP.
LINE OUT:
The full-range signal from this jack can be sent
to a mixing console or additional power amp.
RETURN: Connect this jack to the FX processor’s OUTPUT jack.
‘t I
-
10 db SWITCH:
Press this damping switch to
lower the signal level sent to the input of effects
processors expecting an instrument-level signal
such as stomp boxes.
C
MAINS SOCKET:
Connect the included
power cable (Euro-
norm) to this socket.
The
fuse bracket is
integrated in the socket;
make certain you use
specified replacement
fuses only!
SEND:
Connect this
jack to the FX
processor’s INPUT jack.
SPEAKER OUTPUTS:
Output jacks for connecting external bass speaker cabinets (these jacks
are wired
in parallel). The overall impedance rating is 4 ohms. For instance, you can connect
one 500 watt cabinet with a minimum rating of 4 ohms or two 500 watt cabinets with a
minimum rating of 8 ohms each. If you operate the BASSBASE 400 at a higher impedance
rating, power output will decrease accordingly.
It is very important that you heed the maximum rated handling capacity of any speaker
cabinets you choose to connect, especially if you have borrowed them from someone you
want to remain friends with.
