4
No.
Descrip on
No.
Descrip on
1
Frame
13
Pedal, Le
2
Seat
14
Axle
3
Screw (x2)
15
Washer (x4)
4
Washer (x4)
16
Rear Wheel (x2)
5
Nut (x2)
17
Locking Cap
6
Fender
18
Plas c Bin
7
Fork
19
Screw
8
Front Wheel
20
Lock Bu on
9
Screw (x2)
21
Lights & Sound Unit
10
Washer (x2)
22
Screw (x2)
11
Nut (x2)
23
Cap Nut (x2)
12
Pedal, Right
24
Covers
Assembly
1. Assemble Seat (2) to Frame (1) as shown in Assembly View
2. Insert Screws (3) and Washers (4) into Seat and through Frame.
3. insert Washers (4) and Nuts (5) onto Screws and ghten securely.
To Unfold the Product:
1. Push the lock bu on (20) located on the right side of the unit, under the seat. This
releases the folding mechanism spring-loaded latch.
2. Pull the rear axle away from the front axle un l the unit starts to unfold.
3. Gently push down on the seat un l the folding mechanism latches into place.
4. Ensure the folding mechanism is latched by gently pulling upward on the seat.
To Fold the Product:
1. Push the lock bu on (20) located on the right side of the unit, under the seat. This
releases the folding mechanism spring-loaded latch.
2. Gently
li on the seat un l the unit starts to fold.
3. Push the front and rear axles together un l the folding mechanism latches into
the folded posi on.
4. Ensure the folding mechanism is latched by gently pushing downward on the seat.
A
B
6551 Cen
Centerville O
MADE IN CHINA
CLOSE
OPEN
$$$/5
9
$$$/5
9
$$$/5
9
CLOSE
OPEN
22
21
24
24
23
7
5
Lights & Sound (L&S) Assembly:
Assembly hardware is located in the parts bag with
the product.
1. Locate the L&S (21) on the Fork Stem (7) with
(supplied)
Ba ery Replacement:
Ba eries: DC 1.5V, AAA (included). The unit requires 3 ba eries.
1. Open the door on the rear of the unit.
2. Loosen the ba ery compartment cover screw to remove the cover.
3. Insert
ba eries in the orienta on shown inside the compartment.
4. Re-install the compartment cover and ghten the screw.
Remove Pull
Tab for ba ery
opera on
control bu ons toward the rider.
2. Align the holes in the stem with those in the L&S.
3. Insert
and
ghten the Screws (22) and Cap Nuts (23) using the tool supplied.
4. Ensure hardware is secure so that it will not come loose.
5. Be careful not to over- ghten the hardware. This can damage the L&S and strip
the threads in the hardware. Recommended torque is 88in-lbs (10Nm).
6. Snap the front and back covers (24) over the installed hardware.
