5
6. MAKE THE ELECTRIC
CONNECTIONS
WARNING
: To avoid possible electrical
shock, be sure electricity is turned off at the
main fuse box before wiring.
NOTE:
This remote control unit is equipped
with 16 code combinations to prevent
possible interference from or to other remote
units. The frequency switches on your
receiver and wall transmitter have been
preset at the factory. Please recheck to make
sure the switches on transmitter and receiver
are set to the same position, any
combination of settings will operate the fan
as long as the transmitter and receiver are set
to the same position.(Fig. 10)
Step 1. (Fig. 11) Insert the receiver into the
mounting bracket with the flat side of the
receiver facing the ceiling.
Step 2. (Fig. 12 and 13) Motor to Receiver
Electrical Connections: Connect the black
wire from the fan to black wire marked "TO
MOTOR L" from the Receiver. Connect the
white wire from the fan to the white wire
marked "TO MOTOR N" from the Receiver.
Connect the blue wire from the fan to the
blue wire marked "For Light" from the
Receiver. Secure the wire connections with
the plastic wire nuts provided.
Figure 10
Figure 9
Figure 11
Code switch
ON
ON
Receiver
Transmitter
Receiver
Hanger
bracket
INSTALLATION OF SAFETY
SUPPORT
An additional safety support is provided to
prevent the fan from falling. Secure the
safety cable to the ceiling joist with screw
and washer, as illustrated in Figure 9.
Hanger bracket
Safety cable
