HUDSON STEEL Leg Press/Hack Squat Station, Owner'S Manual

Page: 12 / 18

Step 3
1. Attach Linear Shaft (#32) to Right and Left Frame (#3,#4) then install 2
Aluminium Pillow Block Bearing (#31) onto each Linear Shaft (#32), secure
the Linear Shaft (#32) to Right and Left Frame (#3,#4) using:
two 5/16"-18*115 HHB (#70) two <P8.5*<t>22*2 Washer (#71)
two <P10*<P13*2 Spacer(#33)
two <P38 Plug (#68)
2. Attach Carriage (#5) to Aluminium Pillow Block Bearing (#31) using (If
necessary take off Stop Beam (#29) ):
eight 3/8"-16*16 HHB (#73)
eight 3/8" Spring Washer (#72)
3. Complete underside of Carriage (#5) assembly using:
one Weight Holder (#7) one Connecting Tube (#6)
four M12*75 BHCS (#56) three <P13*<t>24*1.5 Washer (#49)
three M12 Nylon Lock Nut (#61)
two M10*75 BHCS (#55)
six<P11 *¢20*2 Washer (#48)
four M 10 Nylon Lock Nut (#60)
four<P13*<P38*2 Washer (#67)
two ¢11 *<P38*2 Washer (#66)
one Small Foot Plate (#8) two M10*60 BHCS (#54)
4. Attach Left and Right Handle Bars (#10, 11) to Carriage (#5) using:
two M10*75 BHCS (#55)
two M10*25 BHCS (#53)
two M10 Nylon Lock Nut (#60)
four <P11 *¢20*2 Washer (#48)
two <P11 *<P38*2 Washer (#66)
NOTE:
Hand tighten bolts and nylon nuts until machine is fully assembled.
-12-