Huck 2480 SERIES, Instruction Manual, Page: 15 / 34

2480 & 2481 series Tooling
(HK970)
Alcoa Fastening Systems
15
5. Unscrew hoses from tool. Drain hoses
into container. Piston can be pushed
to rear of cylinder to drain fluid.
Discard fluid.
6. Disassemble cylinder and piston
assembly. (refer to Cylinder and Piston
Assembly Section)
7. Disassemble switch and cord assembly.
( refer to Switch and Cord Assembly
Section)
1. See FIGURE 6 . Place spacer over
threaded end of piston. Thread piston
assembly tool onto piston. If cylinder
contains fluid, push piston to rear and
drain into container. Discard fluid.
2. Remove pintail deflector from tool by
twisting and pulling in one motion.
With a 1 5/16 open end wrench,
unscrew end cap.
3. Thread piston insertion tool into
cylinder- - FIGURE 6.
C
YLINDER AND
P
ISTON
A
SSEMBLY
(Refer to Figure 6 through 6c.)
Figure 6
Figure 6a
D
D
ISASSEMBLY
ISASSEMBLY
(
(
CONTINUED
CONTINUED
)
)