18
● Do not mix new and old batteries ● Do not use a discharged battery
● Do not cross-use different types of batteries at the same time
A A
A A
A A
A A
A A
A A
Open the compartment hatch
and remove the battery pack.
5.4 Battery installation
A A
A A
Mode 1: Push the left stick to the upper left corner and the right stick to the upper right corner. Power the
transmitter on while holding both sticks in their respective positions; the LCD screen will show “Calibrate
Sticks Mode 2”. Let go of the sticks, then pull them up, down, towards the center and outwards. Repeat this
sequence 3 times, then release both sticks and hold the “Exit” key until the transmitter beeps. This indicates
a successful calibration.
Mode 2: Push both sticks to the upper left corners. Power the transmitter on while holding both sticks in their
respective positions; the LCD screen will show “Calibrate Sticks Mode 2”. Let go of the sticks, then pull them
up, down, towards the center and outwards. Repeat this sequence 3 times, then release both sticks and hold
the “Exit” key until the transmitter beeps. This indicates a successful calibration.
5.5 Transmitter stick calibration (Mode 1 and Mode 2 throttle settings)
Insert 8 AA batteries into the slots of the
battery pack. Take note to make sure
the polarities are correctly matched.
Plug the battery pack back into the
compartment. Close the
compartment hatch and screw it shut.
