05
2.4 Protection Against Water & Dampness
2.5 Correct Operation
2.6 Pay attention to the rotating blades
For safety reasons, use only Hubsan parts for replacement and repair.
During operation, high speed rotating propeller blades can cause serious bodily
injury or damage to the aircraft. Do not approach the aircraft in flight and do not let
it fly out of your line of sight. If this happens, disarm the motors or power off the
aircraft immediately.
2.7 Avoid Flying Alone
Beginners should avoid flying alone before learning and mastering flying skills. It is
recommended to operate under the guidance of an experienced pilot.
There are many small electrical components in the model. It is important to store/fly
the model in a suitable environment and to avoid placing it around other appliances.
Exposing the model to water or a humid environment may cause failure and damage.
This battery is prohibited for non-designated devices.
Do not touch any kind of liquid waste or byproduct from batteries. If skin or
clothes come incontact with these substances, please flush with water!
Do not mix other types of batteries with lithium batteries.
Do not exceed the specified charging time.
Do not place the battery in a microwave or in areas of high pressure.
Do not expose the battery to the sun.
Do not use in environments with high static electricity (64V and above).
Do not use or charge in temperatures below 0 ℃ and above 45 ℃.
If a newly purchased battery is used, leaking, possesses a bad smell or any
other abnormality, return immediately to the vendor.
Keep away from the reach of children.
Use a dedicated battery charger and follow all charging requirements.
Minors who use the battery and its dedicated unit must be supervised by an
adult at all times.
3 PRE-FLIGHT CHECKLIST
• Before operating, fully charge the remote control and the aircraft.
• Before turning on the switch, check that throttle is in its lowest position.
• Check the aircraft chassis and propellers carefully. Broken or failed parts may cause
danger.
• Turn power on the remote control first, then the aircraft. After use, first power off
the aircraft and then the remote control. An incorrect operation sequence may result
in losing control of the aircraft.
