●
0x08
Query average power loss, Parameter: no, answer: 1 Byte
power loss in % of the current threshold
●
0x09
Query Error, Parameter: no answer 1 Byte Error:
Bit 0: short circuit-current
Bit 1: Overc
Bit 2: Overcurrent –
Bit 3: power loss +
Bit 4: power loss –
Bit 5: Heatsink overtemperature
Bit 6: Overtemperature transformer
Bit 7: Hardware failure
●
0x10
Set start configuration, Parameter: 1 Byte configuration (default 0x0C):
Bit 0: 50R-input relay (0: off, 1: on)
Bit 1: 100k-input relay (0: off, 1: on)
Bit 2: operating v (0: low, 1: high)
Bit 3: operating voltage – (0: low, 1: high)
●
0x11
Query start configuration, Parameter: no, answer: 1 Byte configuration
●
0x12
Set address, Parameters: 1 Byte address (1...99)
●
0x13
Query address, Parameters: no, answer: 1 Byte address
●
0x14
Query amplifier type, Parameters: no, answer: 1 Byte type (0x10)
●
0x15
Query firmware revision, Parameters: no, answer: 1 Byte revision
●
0x16
Set hardware revision, Parameters: 1 Byte revision (e.g. 0x21 = 2.1)
●
0x17
Query hardware revision, Parameters: no, answer: 1 Byte revision
●
0x53
Set Interlock Mode, Parameter 1 Byte (0: Latching 1: Live)
●
0x54
Set Interlock, Parameter 1 Byte (0: Reset at Latching Mode)
●
0x55
Query Interlock Mode, Parameter: no, answer: 1 Byte
(0: Latching 1: Live 2: Off)
●
0x56
Query Interlock Signal, Parameter: no, answer 1 Byte (0: off, 1: on)
6.2 Remote Command Examples
Frame: <length> <address> <command> <parameter>
6.2.1 Setting 50 Ω Input on (Amplifier address: 1)
Command frame: 0x04 0x01 0x02 0x01 (all values are in hexadecimal notation)
Response frame: 0x03 0x01 0x02
6.2.2 Query Heatsink Temperature
Command frame: 0x03 0x01 0x06
A1230-02
Integration into Automated Test Systems
Page 23
