2112 Fenton Logistics Park Blvd
Fenton, Missouri 63026 USA
P/N KIL00921498 FORM NO. K1498 ECO-6-023-19 R04/19
Page 4 of 4
Snap on Wire Guard
MAINTENANCE INSTRUCTIONS:
CAUTION:
Disconnect the supplying circuit before opening fixture or removing optics. To maintain maximum light output, this fixture
should be cleaned periodically. Maintenance procedures sometimes require fixtures to be hosed down for good
housekeeping. The supply circuit
must
be turned
OFF
and the fixture lens
must
be allowed to cool to the ambient room
temperature before cleaning. Only mild, non-abrasive cleaning agents should be used. The force of water applied by a
hose must not exceed 65 gallons per minute coming from a
1” diameter hose applied at a distance of 10 feet
.
HIGH VIBRATION AREAS
:
Periodic inspection of fastener tightness is required; recommended every six (6) months.
Technical information, advice and recommendations contained in these documents are based on information that
Killark believes to be reliable. All the information and advice contained in these documents is intended only for use
by persons having been trained and possessing the requisite skill and know-how and to be used by such persons only
at their own discretion and risk.
The nature of these instructions is informative only and do not cover all of the details, variations or combinations in which
this equipment may be used, its storage, delivery, installation, check out, safe operation, and maintenance. Since
conditions of use of the product are outside of the care, custody and control of Killark, the purchaser should determine the
suitability of the product for its intended use, and assumes all risk and liability whatsoever in connection therewith.
REMEMBER TO SAVE ONE OF THESE SHEETS FOR MAINTENANCE PERSONNEL
New fixtures with batteries can be stored for 2 years in a -20°C to 30°C ambient without a need of recharge. A
fully discharged unit should not be stored more than 6 months without being recharged. There is low voltage
disconnect of the battery to the emergency drivers, however as the batteries still have self-discharge they should
be recharged within 6 months to prevent the cells from permanent capacity loss. For long term storage, turn the
battery switch to the “off” position to prevent the cells from permanent capacity loss.
