Pub. 42004-501C
Division 2 VoIP Telephones
—Wired and WiFi
Page 18 of 22
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-501C.docx
03/20
Output Contacts
Each RED ALERT WiFi VoIP telephone contains two dry-contact outputs (see the Specifications section
for the output ratings). Both outputs are SPST (single-pole, single-throw) contacts. The mode of each
output is configurable. Configure outputs for one of the following modes:
•
On
•
Off
•
Ring
•
Connect
•
Hook
•
In Use
•
Ring Out
•
Registered
•
Emergency
The duration of activation, or on/off times, is configurable in some modes. Refer to Pub. 42004-548, for
programming instructions for the outputs (see the Reference Documentation section).
Maintenance
Status Indication
Power
The
ON
LED, located on the VoIP PCBA (see ), illuminates when power is applied to the telephone.
Heartbeat
The
HB
LED, located on the VoIP PCBA (see Figure 13), flashes when communication over the LAN is
established.
Link
The
LNK
LED, located on the VoIP PCBA (see Figure 13), indicates an active network connection when
illuminated.
Speed
The
SP
LED, located on the VoIP PCBA (see Figure 13), indicates a 100 Mbps network connection
when illuminated or a 10 Mbps connection when off.
WiFi Activity (WiFi Units Only)
The WiFi Activity LED located on the WiFi module will turn ON when the VoIP telephone is powered
and flash when data is being transmitted (see Figure 13).
WiFi Ready (WiFi Units Only)
The WiFi Ready LED is a green LED on the RJ-45 connecter; J2, located on the VoIP carrier PCBA that
illuminates when the WiFi interface is ready to connect to a wireless network (see Figure 13).
WiFi Connected (WiFi Units Only)
The WiFi Connected LED is a yellow LED on the RJ-45 connecter; J2, located on the VoIP carrier PCBA
that illuminates when the WiFi interface is connected to a wireless network or device (see Figure 13).
