45136
ASSEMBLY & INSTALLATION INSTRUCTIONS
Double Ursa 302507
B427
1.
Remove screws (T) from side brackets on fixture (A).
2. Carefully slide glass (N) into upper decorative assembly (D).
3.
Locate upper rod (R). Insert round end through the decorative assembly (D) until U-shaped piece is aligned with
glass (N). Rotate glass holder 90 degrees so that the u shaped piece fits around the glass (N).
4.
While holding the decorative assembly (D), glass (N) and upper rod (R) together, place on top of fixture so that legs
on the upper decorative assembly (D) slide behind the fixture and align with the side brackets. Make sure that the
square block on the top of the assembly (D) fits over the upper spacer assembly (J).
5.
Slowly let the glass (N) slide down until it sets on the glass shield on the top of the fixture (A).
Note:
Be sure not to drop glass (N) onto glass shield. Both glass pieces could break.
6.
Attach upper decorative assembly (D) to fixture using 2 screws (T).
7.
Adjust upper rod (R) to hold glass (N) vertical. Put thumb screw (L) through square block on the back of assembly
(D), thread into upper spacer assembly (J) and tighten against the upper rod (R).
8. Restore electricity at main breaker.
To Install Upper Glass/Decorative Assembly
(Figure 5 & 6)
7 OF 8
