4
The figure below shows how to adjust the height of the handle
：
4.
Connect the sensor and earphone to the receiver host
Connect the headset to the black socket
of the receiver. Be careful to align the
white marks on the plug and socket. The plug is plug and play, please do not rotate!
5.
Introduction of HZ-B cable fault precise determination point tester receiver
host
5.1 Power on the receiver
The host can be turned on or off after pressing the power on / off key
of the
receiver. After more than ten seconds, the host computer of the receiver is ready to use,
then the
test interface
will be displayed
。
5.2 Battery self-test
When you turn it on, please look at the upper right corner of the monitor to check the
remaining capacity of the alkaline battery. If you find that the percentage of battery power
is close to 25%, please charge it first, and then use it after the power is greater than 50%.
5.3 One-touch knob of HZ-B cable fault precise determination point tester
The receiver host is one-touch single-key adjustment. For the use of one-touch
adjustment keys, please refer to the figure below
：
