31
Fig.5 Plastic support for installing scroll
(3)Try your best to take down the scroll, replace the blank scroll with the new one. After
the new scroll set in the axis, install the scroll on the plastic support in the guide channel
(Please note you must make sure the scroll has been installed reliable and will not fall),
cut the scroll like the style in Picture 6, in order to insert the PRTer well.
Fig.6 Style of paper rolled and paper end
(4) After connecting the power source, simultaneously press
PRT
and
ESC
to make the
PRTer nose rotate. At this time, use your hand to send the paper to the paper entrance
under the PRTer nose, the paper then can enter the nose slowly, until the paper has the
needed length out of the box gate, the scroll has been changed ok, again push up the box
gate, press “Reset” key to stop the paper walking.
3. Color ribbon installation
:
The color bandbox has been installed before the PRTer leaves the plant, but after a period
of time of using, it needs replacing. You may do it according to following steps:
(1) Open the box gate (Try your best to press the box gate above, the box goalkeeper
loosens, then you can put the box gate as far as possible to the great angle by your hand),
you may see the PRTer nose. (See Picture 7, PRTer nose inside box gate).
