11
Attention! For the sake of safety, when test has
been finished, please remove the meter away
from the lead on test.
3.PEAK Test
PEAK test: the maximum current test. The meter will make automatic comparison on the
changes in measured current, indicating the maximum value and maintain it, when the meter is
removed away from the lead on test, the test result will be kept consistently, suitable for the circuit
test on those LCD data hard to be read directly.
Under the normal testing mode, press PEAK button
，
PEAK indication light will be bright,
，
enter
PEAK testing mode. That means the meter will display and automatically keep the maximum value in
the test.
Under any other mode, it must be returned to normal testing mode, and then make PEAK testing
according to the above operation.
Press POWER button to exit from PEAK testing mode, returning to normal testing mode, and it
will display “End” symbol during the exit.
4.Data Maintenance
Under normal testing mode, press HOLD button to keep LCD display, “HOLD” symbol displays.
Press HOLD button again to release data lock, returning to normal testing mode, and “HOLD”
symbol disappears.
5.Data Memory
Under normal testing mode, press HOLD to storage data, at the same time, Meter will
automatically form serial numbers, and memory the current preserved data. During the storage,
“MEM” symbol will show once by flash. This meter can memory 99 groups of data, in case of full
storage, “FULL” symbol will display by flash continuously, and it cannot continue to memory until
cleaning out the previous memory.
6.Data Reference
Under normal testing mode, press PEAK + POWER button to enter data reference mode,
displaying “MR” symbol, meanwhile, it will automatically display data saved in the group 01. Then
press PEAK or POWER button to read the stored data by turning upwards or downwards in cycle. It
will return to the group 1’s data automatically after reaching the last group’s data in storage.
Press HOLD button to exit from data reference mode, returning to normal testing mode. During
the exit, it will display “End” symbol.
