10
Please input carefully according to the transformer nameplate while inputting information as all
information is automatically saved together with the test result and incorrect input may affect the
contents of the report.
Scanning Mode Confirmation and Modification
1
、
Selection of Scanning Mode
Click “End Frequency”
to select test stop frequency and then the system will automatically set
parameters to the set parameters according to the set scanning parameters, including start frequency,
scanning mode, and scanning point number. To adjust, click the parameter label in area A to switch
automatically (the label automatically turns green when the mouse pointer moves to a changeable label).
2
、
Change of Default Information
To readjust the default setting information, click“End Frequency”
key with right mouse button
to let the function menu pop up. The information setting window (as shown in the figure below) will pop
up when “setting” is selected, where you may adjust the default scanning information and restart the
software after adjustment. Then the system will test with the adjusted default information.
The above adjustment is used for setting of default information that is distinguished by the value of
“stop frequency”. Actually, adjustment is generally performed as required during the first time use in
practical application and is not performed later unless there is regulation or special requirement.
3
、
Change of Scanning Parameters
Change of scanning parameters is used for testing of complicated parameter combinations. The
system doesn’t have memory function and will recover automatically once quit.
Click parameter label in the curve display area (A) before scanning to change information other than
stop frequency in the manner of cyclic adjustment.
Change of scanning parameters is applicable to single test with measuring result requirement or for
