Device Installation/ 设备安装
2
Align the screw holes on the wall mount with the screw holes on the pole mount, and use the M8 screws to
secure the bracket.
将壁装支架上的螺孔与抱装支架上相应的螺孔对齐，拧紧 M8 螺钉。
Open up the three steel straps and thread them through the installation holes on the pole mount. Thread the
cables that need to connect to the pigtail cables of the PTZ dome camera through the pole mount and wall
mount. Then use the hose clamps to affix the pole mount to the pole.
将 3 个钢带解开，穿过抱装支架的安装孔。将需要与球机尾线对接的线缆穿过抱装支架和壁装支架。将抱箍环绕在柱杆上，
拧紧抱箍，将抱装支架固定在柱杆上。
B. （Optional）Install the optical module/（可选）安装光模块
C. Pole-Mounted Installation/ 立杆抱装
Use a 2# Phillips screwdriver to remove the bottom cover, insert the SD card.
使用 2# 十字螺丝刀将球机窗口盖卸下，插入 SD 卡。
Use a #2 Phillips screwdriver to open the SFP optical module cover on the top of the PTZ dome camera, install
the optical module, and connect fiber-optic cables to the module. Then, close the module cover and tighten the
screws to prevent water from entering the device.
使用 2# 十字螺丝刀打开球机顶盖上的 SFP 光模块盖，安装光模块，并连接光纤和光模块；装回光模块盖时确保拧紧全部螺丝，
避免存在进水风险。
C. Pole-Mounted Installation/ 立杆抱装
1
3
Interface No.9, SFP_RX/TX
光纤接口线
SFP Optical module
光模块
A. SD Card Installation/ 安装 SD 卡
CAUTION/ 注意
• Do not install the camera in a place that human eyes can look straight into. Install the camera over 6 m above the
ground. Keep the camera far away from human eyes to prevent the laser in the lens from impairing human eyes.
Do not place flammable stuff within 20 cm in front of the camera to prevent fire. Do not remove the lens protective
film before the installation completes.
• 镜头内含有激光器，严禁安装在人眼可以直视的位置，球机安装在离地面6m以上的高度，确保球机离人眼位置足够远，以防
激光对人眼造成伤害。镜头前方20cm内严禁有易燃物体遮挡，以防发生火灾。安装完成前切勿撕下镜头保护膜。
• Do not disassemble the camera yourself. Ensure that the weight bearing capacity of the pole, ceiling, wall, and
bracket exceeds 52 kg and the installation environment is secure. Also, avoid magnetic interference nearby. To
improve GPS performance, install the camera outdoors and ensure that the camera is free of obstacles above.
• 禁止私自拆解球机。安装此设备的立杆、天花板、墙壁和支架，需确保在承重52Kg时稳定性较好，并确保各安装环境牢靠。
同时，应避免球机附近存在磁场干扰。为了确保GPS功能，须将摄像机安装在室外，且上方无遮挡。
