Device Installation/ 设备安装
C. Beam-mounted Installation/ 横臂安装
2
3
Unfasten the three hose clamps and thread them through the installation holes on the pole-mount bracket.
Place the hose clamps around the beam and tighten them to affix the pole-mount bracket firmly onto the
beam.
将 3 个喉箍环穿过抱装支架的安装孔，并环绕在横臂上，拧紧喉箍。
使用喉箍将抱装支架安装到横臂上。
Adjust the surveillance angle. Fasten all screws on the universal joint and use captive screws to fasten the two
planes of the universal joint to fix the universal joint. Then, adjust the position of the sunshield.
调整好监控角度，拧紧万向节上的所有螺钉，再使用辅助紧固螺钉在万向节的两个面上拧紧，使万向节固定。同时调整好
遮阳板位置。
d: Move it back and
forth. Then, you can
adjust the position of
the sun shield.
d ： 通 过 前 后 移 动 此 位
置，可调节遮阳板。
4
a
b
c
d
NOTE/ 说明
D. Pole-mounted Installation/ 抱柱安装
1
Fix the camera to the universal joint with two screws in No. 1 holes. Loosen screws a and b on the universal
joint for the universal joint to rotate freely. Adjust the horizontal and vertical shooting angles and tighten all
screws on the universal joint.
通过标识 1 位置的两个螺钉将摄像机固定到万向节上，拧松万向节上的 a 和 b 螺钉，使得万向节可以自由转动。初步调
整好水平和垂直监控角度，拧紧万向节上的所有螺钉。
2
Install the wall-mount bracket into No. 5 holes on the pole-mount bracket (for the No.5 hole identifier, see
the silk screen on the physical device).
将壁装支架安装到抱装支架 5 号孔位（5 号孔位标识请参见实物上的丝印）上。
a
b
1
