Installing the AP
Select an appropriate installation position and leave more than 20 cm space above and around the device for cooling air
circulation.
WA635SN-GN dimensions (unit: mm) without a backplane
support
The WA635SN-GN can be installed using a wall-mounting template (for wall-mounting installation) or wall-mounting bracket
(for wall-mounting or ceiling-mounting installation).
To wall-mount the device using a wall-mounting template, perform the following operations:
3. Use a Phillips screwdriver to tighten four self-tapping
screws into the expansion tubes. Leave a 3 mm space
between the screw head and the wall.
4. Align the cucurbit holes at the rear side of the AP with the
screws on the wall and hang the AP on the screws. Hold
the AP with one hand and press the AP downwards with
another hand to secure the AP on the wall. The AP can be
installed with antennas upwards or downwards, which
depends on cable routing.
1. Use a marker to mark four installation holes on the wall.
35
3mm
a
b
2. Use #6 drill bit to drill 25-30 mm deep holes in the drilling
positions. Hammer the expansion tubes into the holes until
the expansion tubes are embedded into the wall.
Underfloor cabling
Overhead cabling
Recommended WA635SN-GN installation space (unit: mm)
1
5
0
130
4
