25
HUAWEI MG301 B2B Module
HardwareGuide
Description of the Application Interfaces
Figure 3-9
The signal through the RING after the MG301 B2B receives an SM
When an MG301 B2B Module receives a voice call, a periodical low level signal for 1s
and a high level signal for 4s are output by RING, as shown in Figure 3-10 .
Figure 3-10
The signal through the RING after the MG323 B2B module receives a voice call
4s
4s
4s
1s
1s
1s
For detailed application of the MG301 B2B UART1 interface, see
HUAWEI Module UART
Serial Port Design Guide
.
The maximum level of UART1_DCD, UART1_RING, UART1_DSR and UART1_DTR
signals is 3.2 V, and the maximum level of UART1_TD, UART1_RD, UART1_CTS and
UART1_RTS signals is 3.25 V. Therefore, if the UART signals need to be connected the
signal with 3.3 V, a level conversion curcuit is required.
UART1 interface must be powered on after the module is powered on to avoid the wind
blow in which may cause the module cannot work properly.
The level of RS-232 Transceivers must match that of the MG301 B2B module.
3.7
SIM Card Interface
3.7.1
Overview
The MG301 B2B module provides a SIM card interface complying with the ISO 7816-3
standard and supports automatic detection of a Class B SIM card or a Class C SIM
card. Table 3-7 lists the SIM card interface signals.
Table 3-7
SIM card interface signals
Pin No.
Signal Name
I/O
Description
1
SIM_CLK
O
Clock signal of the SIM card
3
VSIM
P
Power supply of the SIM card
5
SIM_DATA
I/O
Data signal of the SIM card
7
SIM_RST
O
Reset signal of the SIM card
Huawei Proprietary and Confidential Copyright ©
Huawei Technologies Co., Ltd
Issue 06 (2013-06-13)
