Device Installation/ 设备安装
D. Wall-Mounted Installation/ 墙壁安装
3
E. Pendant-Mounted Installation/ 吊顶安装
1
Use screws to fix the camera to the pendant mount. Unfasten the screws on the universal joint to enable the
universal joint to rotate freely. Adjust the vertical shooting angle and tighten all screws on the universal joint.
通过标识 1 位置的螺钉将摄像机固定到吊装支架上。初步调整好垂直监控角度，拧紧万向节上的所有螺钉。
5
Adjust the surveillance angle. Fasten all screws on the universal joint and use captive screws to fasten the two
planes of the universal joint to fix the universal joint. Then, adjust the position of the sunshield.
调整好监控角度，拧紧万向节上的所有螺钉，再使用辅助紧固螺钉在万向节的两个面上拧紧，使万向节固定。最后调整
好 c 处遮阳板的位置。
2
Place the mount in the desired installation position. Use a marker to mark the screw installation locations.
Select a drill bit with a diameter of 8 mm to drill holes with a depth of about 45 mm. Use a claw hammer to
drive the white expansion bolts into the holes. Use screws to fix the wall mount to the wall.
将支架放置于安装位置 , 使用记号笔绘制螺钉安装位置，选择直径为 8mm 的钻头，钻取深约 45mm 的导孔。使用羊角
锤将白色膨胀螺栓打入钻好的孔内，使用螺钉将吊装支架固定到墙壁上。
3
Adjust the surveillance angle. Fasten all screws on the universal joint to fix the universal joint. Then, adjust
the position of the sunshield.
调整好监控角度，拧紧万向节上的所有螺钉，固定万向节。最后调整好 b 处遮阳板的位置。
b
c
NOTE/ 说明
a: Loosen the screw here. Then, you can adjust the vertical angle of the camera.
a：通过拧松该处螺钉，可调节摄像机垂直角度。
a
a
1
b
E. Pendant-Mounted Installation/ 吊顶安装
