Figure 5-57
Shielded RJ45 connector
1: Core wires
2: Aluminum foil
3: Braid shield
4: Outer jacket
5: RJ45 connector
Procedure
Step 1
Strip 20 mm outer jacket off the network cable, peel off the braid shield backward, and cut off
the aluminum foil and protection band, as shown in
NOTICE
Ensure that the shielded layer is intact when stripping outer jackets off the network cable.
Keep the cable insulation intact when stripping the shielded layer.
Figure 5-58
Stripping the cable
AP4050DN-E
Hardware Installation and Maintenance Guide
5 Appendix
Issue 05 (2018-02-02)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
67