Product
Instructions
PI-PF 566418 0518 ManaBloc Access Panel Installation (EN ES FR)
1 of 2
Viega LLC, 12303 Airport Way, Ste. 395 • Broomfield, CO 80021 • Ph: 800-976-9819 • Fax: 800-976-9817
ManaBloc
®
Access Panel Installation
WARNING
The ManaBloc access panel is
designed to fit between 16" on center framing. If other
than 16" on center framing is present, additional bracing
will be needed.
Assembly instructions:
Using your ManaBloc part number and chart below, determine
the proper cut-out size.
Part No. Max. Ports Dimensions
Cut out
Outside
50718
14
14" x 18"
14
⅜
" x 19¾" 16½" x 21¼"
50726
16
14" x 26"
14
⅜
" x 27¾" 16½" x 29¼"
50730
24
14" x 30"
14
⅜
" x 31¾" 16½" x 33¼"
50739
36
14" x 39"
14
⅜
" x 40¾" 16½" x 42¼"
Panel
Insertion
Slots
1. Cut and remove the section of dry wall over the
ManaBloc, centering the opening between the
studs. Ensure that all tubing connections and valves
are accessible.
2. Remove the panel from the frame by lifting the bottom
of the panel up and outward. Then remove from the
top frame slot with a downward motion.
3. Place frame, with the small slot at the bottom, into
the dry wall opening, resting the frame on bottom of
the opening.
4. Lift frame up ¼" and use provided hardware to secure
frame to studs, being careful not to over-tighten.
5. Replace the panel by inserting top edge of panel into
the upper frame slot. Then, while pushing the panel in,
lower into bottom slot of frame.
1
3
4
2
5
This document subject to updates. For the most current Viega technical literature please visit www.viega.us.
Viega products are designed to be installed by licensed and trained plumbing and mechanical professionals who are familiar
with Viega products and their installation.
Installation by non-professionals may void Viega LLC’s warranty.
