HTW SPACE HTWPUR24SPA, Owners And Installation Manual

Page: 49 / 64

Fault handling
This chapter list the possible problems when using this product. If you can't solve the problems
based on the below information, please contact with our customer center or dealers.
Condition
Machine can't
turn on
The fan doesn't
work
Performance is
poor or not best
purification ability
Possible reasons
The front panel may not be installed.
The power plug or wire is damaged.
The machine is not turned on.
Insert the power source, and turn on the machine
again.
The dynamo is damaged. Contact with our customer center or dealers.
The machine is put on the uneven place. Remove the machine to the flat place.
Contact with our customer center or dealers.
Contact with our customer center or dealers.
Please clean the cleaning mesh filter.
Replace one set of new filters.
Contact with our customer center or dealers.
To ensure the machine work in the suitable area.
Before using, please remove plastic packaging of
each filter.
To ensure that all the filters
are on
the
correct sequence in the machine.
To ensure the machine at least 50 cm clearance on
both sides of the air inlet and the outlet at the back
of the machine at least 10 cm.
The motor is loose.
Washable mesh filter is dirty.
Filter has not been replaced.
Machine inlet or outlet was blocked.
The gap round the machine is not proper.
Machine filter missing or sequence error.
Exceed the expect cover area.
Plastic packaging of each filter is not
removed.
Plastic packaging of each filter is not
removed.
Before using, please remove plastic packaging of
each filter.
Loose or foreign particles inside the
machine.
Contact with our customer center or dealers.
Power plug is not inserted into the power
source
Pull out the power plug, then insert into the power
source.
To remove the front panel, then install the panel
again.
Possible solutions
48