HTW ECO-THERMAL, Owner'S Manual

Page: 54 / 152

21
The FOR SERVICEMAN is used for installer or service
engineer. It is NOT instended the home owener alters
setting with this menu.
It is for this reason password protection is requierd to
prevent unauthorised access to the service settings.
The password is 234.
6.9.3 How To Exit For SERVICEMAN
Active the setting and exit?
NO YES
CONFIRM
OK
FOR SERVICEMAN
If you have set all the parameter.
Press ''BACK'', the following page will appear
：
Select ''YES'' and press ''OK'' to exit the FOR
SERVICEMAN.
After exiting the FOR SERVICEMAN, the unit will be
turned off.
ADJUST
6.10 Network Configuration Guidelines
Do you want to restore the
WLAN setting and exit?
NO YES
CONFIRM
OK
RESTORE WLAN SETTING
The wired controller realizes intelligent control with a built-in
module, which receives control signal from the APP.
Before connecting the WLAN, please check for it if the router in
your environment is active and make sure that the wired
controller is well-connected to the wireless signal.
During the Wireless distribution process, the LCD icon “ ”
flashes to indicate that the network is being deployed. After the
process is completed, the icon “ ” will be constantly on.
6.10.1 Wired Controller Setting
The wired controller settings include AP MODE and RESTORE
WLAN SETTING.
ENTER
OK
WLAN SETTING
AP MODE
RESTORE WLAN SETTING
Activate the WLAN by interface. Go to "MENU"> "WLAN
SETTING"> "AP MODE".
Press"OK", the following page will appear:
Use ''◄''
，
''►'' to move to"YES", press "OK" to select AP mode.
Select AP Mode correspondingly on the mobile device and
continue the follow-up settings according to the APP prompts.
CAUTION
After enter Ap mode, if it’s not connected with mobile
phone, the LCD icon " " will flash 10 minutes then
disappear.
If it’s connected with the mobile phone, the icon " "
will be constantly display.
Restore WLAN setting by interface. Go to “MENU”> “WLAN
SETTING” > “RESTORE WLAN SETTING” .
Press"OK", the following page will appear:
Use ''◄''
，
''►'' to move to "YES", press ”OK” to restore
WLAN setting.Complete the above operation and wireless
configuration is reset.
AP Mode connecting WLAN:
6.11 SN VIEW
HMI NO.
***********************************************
SN VIEW
IDU NO.
********************************
ODU NO.
********************************
SN VIEW
#1
Do you want to activate the
WLAN network and exit?
NO YES
CONFIRM
OK
AP MODE