N50 Imaging Unit Series
│ Quick Installation Guide
14
4.
IP Configuration
4.1Default IP address
The N50 imaging unit is a network-based unit, an IP address is assigned by the manufacturer. The unit’s
default IP address is
192.168.0.30
and subnet mask is
255.255.255.0
.
IP CONFIGURATOR is a utility program that helps users to locate the imaging unit in local area network.
4.2Operating the "IP configurator" utility from your LC (Lane Controller)
The IP configurator utility is already installed on the Lane Controller LC-1000 or LC-2000.
The utility icon is displayed in the following image:
F
IGURE
4-1:
IP CONFIGURATOR ICON
4.3Installing the "IP configurator" utility from HTS web site
In addition, the utility is available on our Web site:
http://htsol.com/Support
Select in Download: Tools and Utilities the "IP configurator utility ".
4.4Installing new IP address
The steps to get the utility running are listed below:
1. Make sure the Imaging Unit and your Lane Controller are in the same subnet.
2. Connect the Ethernet connector from the N50 imaging unit to the LC directly or VIA switch.
3. Open the application IP configurator (you can find a shortcut on the LC desktop)
4. Enter default Username:
admin
5. Enter default Password:
1234
6.
Press the discover button
F
IGURE
4-2: L
OGIN
W
INDOW
The window would list information of units in operation at present on the network.
Select the block that contains: Imaging Unit model N50, IP and Firmware.
