HTL DSX Series, Operating Instructions Manual

Page: 4 / 12

4
malfunction, do not reverse connectors. Do not try to loosen the swivel assembly at any
moment.
Connect the twin - line hose to the swivel as shown:
Drive direction change
To remove the square drive, disengage the drive retainer assembly by depressing the round
center button and gently pulling on the square end of the square drive. The square drive will
easily slide out.
To insert the drive in the tool, place the drive in the desired direction, engage drive and bushing
splines, then twist drive and bushing until ratchet spline can be engaged. Push drive through
ratchet. Depress drive retainer button, engage retainer with drive and release button to lock.
The following diagram illustrates the direction the square drive should face for loosening and
tightening of a standard right hand fastener:
Reaction arm
The reaction arms are employed to absorb and counteract forces created as the unit operates,
which should extend in the same direction of the square drive; however, slight adjustments may
be made to suit your particular application.
In operation, the reaction arm must be fully engaged and secured. To engage the reaction arm,
depress the spring loaded button located on the rear of the end cap, push to position and
release to lock. Ensure the retainer is locked in place prior to using the wrench.
To remove the reaction arm, depress the spring loaded button located on the rear of the end cap
and pull to release.
After determining the desired torque, use the calibration certificate supplied with your wrench to
determine the pressure that is necessary to achieve that torque.
1. Connect the tool to the power supply and turn the pump on.
SETTING THE TORQUE
A
R
Right is
tight.
Left is
loose.