HTC 800 RX
Usage
2.0
29
4.12.1
Standby
To activate the machine's functions, turn the start key to the right; "On". When the key
is in this position, the Power green indicator light on the control panel is lit, indicating
that the machine is in standby mode.
4.12.2
Start the Machine - Radio Control
Note!
To save energy, the radio control unit automatically switches off if a button is
not activated within a given time. in which case, the blinking points in the
display are extinguished.
1. Turn the knob "Radio On/Off" on the control panel to the right, to prepare the
machine for manoeuvring via the radio control unit, the indicator "Radio
Enables" on the control panel lights up.
2. Press the button "EM-STOP" and then press the button to start the radio
communication on the radio control unit to activate the radio control. The
buttons can be activated in any order, but after you have pressed the first button
the second must be pressed within 5 seconds. When the radio control is
activated, the two points start blinking alternately with a red light on the control
unit's display.
3. Zero the radio control unit by doing the following:
- Turn the knob for speed (SPEED) to "min".
- Set the control for driving forwards/backwards (FWD/RWD) in the middle
position.
- Turn the knob for the rotational speed (GRINDING SPEED) to 0%.
- Move the control for starting and stopping the grinding discs' rotation
(ON/STOP) to STOP.
4. Press the button to start radio communication. The communication error
indication (ComError) on the machine's control panel should then go out.
5. Start the grinding discs' rotation by moving the control "ON/STOP" to ON.
Adjust the rotational speed with the knob "GRINDING SPEED".
6. Start the machine's drive motors by moving the control "FWD/RWD" to FWD.
Adjust the speed with the knob "SPEED".
•
Check the wheel's locking, if the machine does not move, see instructions
under Locking the wheels, page
17
.