![background image](http://html1.mh-extra.com/html/htc/800-rx/800-rx_manual_2179101036.webp)
Usage
HTC 800 RX
28
2.0
4.11.4
Overload
If the machine is using too much power, the Overload indicator on the control panel
goes off. The machine switches off automatically after a while if this is ignored. Reduce
the speed of the grinding discs to see if the Overload indicator goes out. If this does not
help, follow the procedure for troubleshooting.
Tip!
If the machine is heavy to operate, it can be due to the placing of the weights.
Fold the weights up or back, to unload the grinding head, see Figure 4-7, page
20
and Figure 4-8, page
20
.
4.12
Manoeuvring via the radio control panel
During radio control, the machine is manoeuvred via the radio control unit,
see Figure 3-4, page
13
.
Warning!
Never leave the machine unattended when operating via the radio control unit.
When operating via the radio control unit, the machine is driven forwards with the help
of the motors in the drive motor box. From a work environment perspective, operation
via the radio control unit is recommended.
The radio control unit and the machine are individually paired, which means that only
the intended unit can control a machine. The identification code can be seen on the
machine sign and on the radio control unit.
1. Loosen the battery cover on the radio control unit by screwing loose the screws
on the cover.
2. Place two charged AA batteries 1.2 V NiMH, or alternatively two normal,
non-rechargeable 1.5 V AA batteries in the battery space.
Note!
Rechargeable batteries must be fully charged before they are used for the
same time.
Warning!
Never attempt to charge standard, non-rechargeable 1.5 AA batteries.
3. Close the cover and fasten it in place with the screws.
•
Check that the wheel lock is secured between the wheel and the drive motor,
see Figure 4-4, page
18
.