Page 1
4
MI TOWER
4
m - ASSEMBLY
STEP 5
Stand inside the tower and fit a platform on to the eighth
rung, making sure that the wind-lock catches engage.
STEP 6
Fit a stabiliser to each corner of the tower. Position the lower
horizontal stabiliser coupler clamp just above the frame’s second
rung, then secure the top stabiliser coupler clamp just above the
frame’s fifth rung. Adjust the stabilisers so that you create as square
a footprint as possible. Adjust each stabiliser’s length so that they are
in contact with the ground. Make sure all coupler clamps are correctly
secured. Extend and lock the four component hangers located on
either side of the platform.
STEP 7
Place two guardrail brace panels on to one set of hangers, and the
toe boards in to the opposite set. Enter the tower framework and
climb the frame rungs until you are half way through the platform’s
trap door. Now manoeuvre yourself so that you are sitting on the
platform, with your legs through the trap door and your feet on the
frame rungs. From this position, you should take each of the guardrail
brace panels, one at a time, and attach so that the upper jaws are
positioned above the twelfth rung.
STEP 8
With both panels in position, you may access the platform. Unfold the
toe board set and position so that they sit on to the outer edge of the
platform. Finally, retract all hangers and the tower is now complete
and ready to use.
332_MI TOWER_12/06/2019
