02/2011
9
english
shredstar
®
LED
-
indicator
Cause
Remedy
No lED lights up
-
Place the cutting head correctly on the base cabinet
and push the containers for shredded paper and CDs in
properly .
Press “
I
” on the switch
.
Both lEDs light up
The shredded
paper container
is full
Empty the container .
If you take the cutting head off the base cabinet, take
care not to damage the flap on the bottom of the cutting
head .
the red led flashes
Overheating
the maximum uninterrupted operating time is five
minutes . let the machine cool down for around
20 minutes .
Only the red lED
lights up
Paper cutting
unit overloaded
Press “
R
” on the switch .
Note:
The cutting unit starts up with a delay of two seconds.
Remove the paper .
Do not feed in more than 18 sheets of paper at a time .
for any other malfunctions, switch off the machine and get in touch with our customer service .
6 Troubleshooting
• Squirt special cutting unit oil (order number
1 .235 .997 .403) through the paper feed
across the entire width of the cutting shafts .
• Without feeding in paper, run the cutting unit
in reverse (
R
) .
This loosens paper dust and particles .
7 Cleaning and maintenance
Push down the front of the container (1), push it
back (2) and lift the container out of the bracket
(3) .
Note that the shredder can only be switched on
when the CD container is properly in place .
1
2
3
Instructions on removing the CD container
8. Cleaning Photo Eye Sensors
• Unplug your machine – for your safety
• lift cd flap on machine(if no flap installed,
disregard this line and continue on)
Note: In the center of the paper slot you should
see 2 transparent squares – one on either side
of the slot
• Use compressed air or take a dry tissue or
paper towel and wipe back and forth a few
times just to dust that area off
• replace flap if necessary
• Plug machine back in
Switch off the shredder and pull out the power
plug . When cleaning only use a soft cloth and
a mild soap-water solution . However, no water
may enter the equipment .
Oil the cutting unit when
cutting performance deterio-
rates or the device becomes
noisy, or every time you
empty the waste container .
Summary of Contents for shredstar
Page 71: ...02 2011 71 ...
