HSM HSM1822, Instruction Manual

Page: 17 / 93

16
SECURIO B 32
06/2013
english
7 Cleaning and maintenance
WARNING
Dangerous mains voltage!
Switch off the shredder and pull
out the mains plug.
When cleaning only use a soft cloth and a
mild soap-water solution. However, no water
must enter the equipment.
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
container (Cross cut
only).
Only use HSM special
lubricating oil for the
cutting unit to do this:
• Spray the special cutting unit oil through
the paper feed along the entire width of
the cutting shafts.
• Let the cutting unit run in the permanent
mode for about 10 seconds without any
paper.

Paper dust and particles are shaken off.
Note:
Oiling the cutting unit also improves the cut-
ting performance of devices with strip cut.
8 Disposal / Recycling
Electrical and electronic old de-
vices contain a variety of valuable
materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.
Check that the door switch is working
properly:
WARNING
If the following procedure cannot
be performed, switch off the docu-
ment shredder, disconnect the
mains plug and contact customer service.
• Insert the mains plug and switch on the
shredder.
• Feed in a sheet of paper and open the front
door while the paper is being drawn in.

The cutting unit must turn off immediately
and the “door open” indicator must light up.
• Close the door.
 The cutting unit must not yet restart.
• Pull the paper out of the feed opening.
The light barrier must be clear.
• Switch off the machine and then switch
back on.
 The cutting unit starts when paper is fed in.