Bedienungs- und Wartungsanleitung für Handschweißextruder Serie HSK10 DE
HSK Kunststoff Schweißtechnik GmbH
25
4.1.1 Start-up
Prior to the start-up of the machine it must be secured that the motor is cut off. If not, the on-off switch
of the drive must be unlocked.
Prior to heating up the manual welding extruder the handle this is delivered with the machine, has to
be mounted onto the cylinder.
After having procured the mains supply by connecting the plug, the heating of the manual welding
extruder is switched on automatically.
By this action there is the danger of injury by burning at the places marked with a
!
in the
following picture:
Please see to it that in
front of the
air pre-heating nozzle
there are no
materials which are easy inflammable or explosive.
Make sure that the set mass temperature (setting process see chapter 5.2) is suitable for the material
to be welded.
With HSK manual welding extruders equipped with electronic regulation of the mass temperature, a
minimum temperature of 180°C cannot be under run.
In special cases this figure can be changed after having contacted the manufacturer or his authorized
agents.
Prior to the feeding of the welding wire the drive has to be switched on.
The welding wire has to be fed with slight pressure. Once the machine has seized the welding wire,
the further intake is done automatically.
