Bedienungs- und Wartungsanleitung für Handschweißextruder Serie HSK10 DE
HSK Kunststoff Schweißtechnik GmbH
23
1. General information
Copyright holder of this documentation is HSK Kunststoff Schweißtechnik GmbH, Bad Honnef. It
contains descriptions, technical drawings and enclosures which may not, neither partly nor entirely, be
copied, distributed, used for competitive reasons or given to third parties without their permission.
These instructions have to be studied thoroughly prior to the start-up of the machine, as the
manufacturer will not accept any liability for damage to persons and/or machine parts resulting from
handling not in line with these directions.
These operating instructions are made for the practical use and should therefore be accessible to the
operator at any time.
Please make sure that prior to repair and maintenance work at the welding extruder, the device must
absolutely be disconnected from the electrical network.
On ordering spare parts the following specifications must be procured:
1. Machine-no.
2. Device (Extruder, drive or air heater)
3. No. of item corresponding to the spare parts list (see p. 15)
All necessary settings and, if necessary, adjustments to be carried out by skilled workers are
described in the present operation manual. Should there, in spite of this fact, occur problems during
start-up, we would ask you not to carry out unauthorized manipulations to the machine. You will
endanger your health and risk to loose warranty. In this case please contact the nearest sales agency
or get in direct contact with HSK
K
UNSTSTOFF
S
CHWEIßTECHNIK
G
MB
H
(see page 21).
2. Technical data
Voltage:
230 V / 50 Hz
Air heating:
1550 W
Cylinder heating:
300 W
Extruder drive:
500 W
Wire:
4 mm
3. Explanation of symbols
Information of special importance in the present operating instructions is marked with the following
symbols:
Information regarding security:
Information regarding maintenance:
