Hospital Systems, Inc.—750 Garcia Ave—Pittsburg, CA 94565
phone: 925.427.7800
fax: 925.427.0800
www.HSIheadwalls.com
1.
Upon power-up the unit will resume display of time and
elapsed time.
2.
To set the React unit, press and hold the letter "R" in the
word React for approximately five seconds, or press the RESET and
the MODE buttons at the same time and hold for 5 seconds. The
units will activate the set-up mode and a blinking 0 in the upper
[orange] row and numbers in the lower [green] row.
3.
Time of Day With the red 0 blinking press the START/STOP
switch and the first green digit will begin to blink, Use the MODE
switch to set the first digit. Press the START/STOP to activate the
second digit and use the MODE to set it. Repeat for the rest of the
digits. Upon completion of the time set, a red blinking 1 will
appear.
4.
Date. With the red 1 blinking press the START/STOP switch and the first green digit will begin to
blink. Continue as in 3 above to set the date.
5.
Brightness. With the red 2 blinking press the START/STOP switch and the last green digit will begin
to blink. Pressing MODE will change the brightness from 0 [dim] to 6 [bright] Do not set at over 6.
6.
Mode, With the red 3 blinking press the START/STOP switch and the last green digit will begin to
blink. Press the MODE switch to change the Mode as follows:
7.
12/24 Hour With the red 4 blinking press the START/STOP switch and the last green digit will begin
to blink. Pressing MODE will change the operation for the time of day clock to
8.
4/6 Digit Display With the red 5 blinking press the START/STOP switch and the last green digit will
begin to blink. Pressing MODE will change the operation for the time of day clock to
9.
Single/Dual Display With the red 6 blinking press the START/STOP switch and the last green digit
will begin to blink. Pressing MODE will change the operation for the time of day clock to
10. Version No. With the red 7 blinking the lower row will display the version number of the unit's
program.
11. Self Test With the red 8 blinking press the START/STOP switch and the last green digit will begin to
blink. Pressing MODE will cycle all digits through all numbers for testing.
12. After self test the unit will revert to operational mode. After setting any of the above, operational
mode can be attained by pressing RESET. Your last changes will be entered only if the red digit is
blinking
when you press RESET.
0
elapsed timer only
1
time of day only
2
date & time of day
3
elapsed timer & time of
day
4
date & elapsed timer &
time of day
0 24 hour time of day display
1 12 hour time of day display
0 24 hour time of day display
1 4 digit display for time of day HH:MM
0 Dual display [elapsed timer in red on
top, time of day in green on bottom
1
Single display, MODE will display either
elapsed time
or time of day in top
[red] row
Operating Instructions
REACT™ Time of Day/Elapsed Timer
©HSI 2014
