HSE24 123526, Instruction Manual, Page: 8 / 24

【
INSTRUCTION
】
1. When install batteries and power on, LCD will display all segments then enter into
the SCAN function mode after one second. Press the MODE key to select the next
function.
2. LCD display function Order: SCAN
>
TMR
>
SPEED
>
DIST
>
CAL
>
PULSE
>
SCAN.
3. When there is signal transmitted to the console without pressing any key, all
function TMW/SPD/DST/CAL will start to count up automatically.
4. TMR – Press the SET key to set target time, the increment is 1:00 minute each
time; If TIME count down to 0:00 from target value, console will stop and 0:00 is
flashing for reminder, press any key to stop it. Then Time will start to count up.
5. SPD – User cannot preset SPEED. When there is signal transmitted to the
console, LCD will display current exercising speed.
6. DST - Press SET key to set target distance, the increment is 1.0 m each time. If
DISTANCE counts down to 0.0 from target value, console will stop and 0.0 is
flashing for reminder, press any key to stop it. Then DISTANCE will start to count
up.
7. CAL – Press SET key to set target CALORIES, the increment is 1.0cl each time.
If CALORIE counts down to 0.0 from target value, console will stop and 0.0 is
flashing for reminder, press any key to stop it. Then CALORIE will start to count up.
8. Pulse-Put your hand on pulse sensor of handrail. Then check the pulse on the
console.
Remark:
1.Without any signal been transmitted into the monitor for 4 minutes, the monitor will
enter to Standby mode.
2. STOP SIGNAL-STOP signal will light up when SCAN function is under executing.
Trouble shooting:
When the display of LCD is weak, it means the batteries need to be changed.
If there is no signal when you pedal, please check if the cable is well connected.